Table Des Matières; Safety; Description - Lincoln 85562 Manuel

LINCOLN WAYSIDE LUBRICATOR
85562, 85563, 85564, 85565
Table of Contents
Safety........................................................................................2
Description................................................................................2
Appropriate Use......................................................................3
Performance and Speci¿ cations.............................................3
Operation...................................................................................3
Installation.................................................................................5
Trouble Shooting Guide..............................................................9
Components Reference...........................................................10

Safety

Read and carefully observe these operating instructions before
unpacking and operating the unit. The unit must be operated,
maintained, and repaired exclusively by persons familiar with
the operating instructions. Local safety regulations regarding
installation, operation and maintenance must be followed.
Operate this unit only after safety instructions and this service
manual are fully understood.
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.
Extreme caution should be used when operating this
equipment as material leaks from loose or ruptured
components can inject À uid through the skin and into the
body causing serious bodily injury. Adequate protection
is recommended to prevent splashing of material onto the
skin or into the eyes.
If any À uid appears to penetrate the skin, get emergency
medical care immediately. Do not treat as simple cut.
Tell attending physician exactly what À uid was injected.
Page Number - 2
SHOP ONLINE at www.airlinehyd.com
Inspection
If over pressurization of the equipment is believed to have oc-
curred, contact the factory authorized warranty service center
nearest you for inspection of the pump and ¿ ttings.
Specialized equipment and knowledge is required for repair of
the pump used in this unit. Contact the factory authorized war-
ranty and service center nearest you for repair or adjustments
other than maintenance speci¿ ed in this manual.
Annual inspection by the factory authorized warranty and ser-
vice center nearest you is recommended.
A list of factory warranty and service centers is available upon
request.
Damaged Pumps
Any pump that appears to be damaged in any way, is badly
worn or operates abnormally, shall be removed from use until
repairs are made. Contact the factory authorized warranty and
service center nearest to you for repairs.

Description

85562-Single track 24 VDC solar
85563-Dual track 24 VDC solar
85564-Single track 110/230 VAC electric
85565-Dual track 110/230 VAC electric
General Description
The Lincoln Industrial Railroad Wayside Lubricators are a high
pressure, positive displacement, positive distribution lubricat-
ing system designed to dispense grease onto the gage face of
railroad track. Units are available with two pumps installed in
the housing for double track installations and can be used with
either two or four wiper bars per pump. The lubrication pump
runs on 24 VDC and is powered either with a 24 VDC solar
panel and batteries, or an AC to DC power converter.
The wiper bars are unique to the industry with a patented
positive displacement distribution and rubber dispensing tip
and brush. Each of the 12 outlet ports in each of the wiper bars
will receive full system pressure in turn to insure even grease
distribution and coverage. Designed to ¿ t neatly beneath the
railhead with only the brush and rubber tip exposed to the rail
car wheel, the wiper bar is well protected from damage due to
wheel strike.
The pump controller uses a counter/timer to counts axle
passes and activates the pump for a pre-set period after a
pre-set number of axles pass the wiper bars. Both of the time
settings are easily adjusted in the ¿ eld. In Dual pump units,
two controllers are used, one for each pump.
The unit housing is constructed of a heat and UV stabilized
high-density polyethylene, with an 800 lb grease© capacity.
This material maintains its high impact properties even at
-40° Fahrenheit.
Form 403834
800-999-7378