Lcd Contrast; Personalizing And Updating The Tester - AgraTronix AG-MAC PLUS Mode D'emploi

LCD CONTRAST

You will likely not need to adjust the LCD contrast since the default setting will
meet the needs of most people. Be careful if you do adjust your LCD contrast
since you may get to either extreme (too high or too low) where you can no longer
see text on your display.
1. Turn on Unit (press ON/OFF button)
2. Use UP/DOWN buttons to scroll to "SETTINGS" then press ENTER
3. Use UP/DOWN buttons to scroll to "Contrast" (Figure 15)
4. Press ENTER
5. Press UP/DOWN buttons until desired LCD contrast is achieved
6. Press ENTER to save new contrast (or press Back Arrow if you don't want
to save this new contrast level)
7. Press Back arrow to return to the active grain display where you are ready
to test

PERSONALIZING AND UPDATING THE TESTER

1. The tester is equipped with a USB port and when connected to the internet
via a computer will allow for diagnostics and updates to its software and
grain calibrations.
2. Visit www.AgraTronix.com to use your USB port for personalization (adding
user name), grain scale, fi rmware and diagnostic updates.
Operation
Figure 15. Contrast Screen
15