Di4 Jet Pressing Pro 5b Mode D'emploi page 21

4. Using both hands holding the base, give the Steam Station a minor shake (be careful not to drop
the iron from its base).
5. Position the Steam Station on its side, then remove the boiler rinse cap cover, and use a coin to
unscrew the plug. ( Fig2 and 3)
6. Fill the boiler with water again (ensure you use tap water), and give it another shake.(Fig4,5 and 6)
7. Repeat this step twice for best results.
8. Screw the plug back in and then place the cap on. (Fig 3 and 2)
CHANGE ANTI-SCALE CARTRIDGE
Water filter cartridge replacement. For moderate use (twice weekly), and depending on the hardness
of the water in your area, the water softening filter and anti-scale cartridge should be replaced every
3 to 6 months.
NOTE: - Do not use the unit without the water softening filter!
1- Remove the water tank by pulling it outwards
2- Pull the cartridge outwards, and unscrew the top part. Inside you will find two filters and a bag with
resin; these should be replaced if they are dirty.
3- Replace the top part and screw it on, place the cartridge once again within the ironing centre.
4- Place the water tank where it was.
21