Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. Connect the
4
Tubes.
4
4
NOTE:
NOTE: Refer to the part list on page 6 for the
exact quantity of
4
total quantity to form the horizontal beams on
the short sides of the pool.
8. Rotate the tube to align the holds of the tube with the openings
on the sleeres.
Swedged End
5
• Align the holes of
4
and
5
with the sleeve openings.
10. Insert the
U-Shaped Pipe take to the strapes at the bottom of
2
the pool.
Tubes. Connect half the
Swedged End
4
• Make sure all the swedged ends of
are pointing to the clockwise direction.
2
7. Carefully slide the connected Short Tubes
into the sleeves on the short sides of the pool.
4
9. Connect the
closed rectanglar pool frame is now frame at the pool top.
NOTE: The Conner Piece
spring pin. THIS IS NORMAL. Only
catch the spring pin.
4
and
5
11. Continue to insert all
2
2
2
2
- 17 -
Swedged End
3
Corner Piece to the takes at 4 Corner. A
3
DO NOT have a hole to catch the
4 5
Tubes have holes to
3
3
3
x4
U-Shaped Pipe.
2
2
4
4
3
2
2
2
2
2
Publicité
Table des Matières
