Installation time is around 15 minutes to 45 minutes.( excluding earthworks and filling).
It will be much easier to install your pool if you unfold it and let it lay in direct sunlight for
about 2 hours prior to installation. This will help to insure a wrinkle-free fit because the pool
material will be more pliable allowing it to form into shape during installation.
• The pool must be assembled on a SMOOTH , LEVEL and FIRM soil that is free of stones, gravel, sticks,
blacktop, or other oil base compounds.
• Do not install pool on a wooden deck or any type of wooden surface.
• DO NOT set up the pool on sand surface.
• DO NOT use sand to level the ground.
• Sand can be washed out, causing the pool to DEFORM and COLLAPSE.
• Do not install the pool over concrete, asphalt or any other hard surface.
• DO NOT select an area under overhead electrical lines, trees, or within 15 feet of a house, building, etc.
• The pool shall be located a minimum distance of 6ft (1.83m) from any electrical receptacle.
• All 220-240 volt, 15 and 20 ampere receptacles located within 20ft (6.0m) of the pool shall be protected
by a residual current device (RCD).The 20ft (6m) distance is measured via the shortest straight line distance
the supply cord would follow without piercing a floor, wall, ceiling, doorway, window, or other permanent
barrier.
• DO NOT attempt to assemble this pool in adverse weather conditions, windy conditions, or when the
temperature is below 16ºC (60ºF).
FAILURE TO FOLLOW THE INSTRUCTIONS ABOVE WILL CAUSE POOL TO COLLAPSE AND
MAY RESULT IN PERSONAL INJURY AND WILL VOID THE WARRANTY.
S E T U P I N S T R U C T I O N S
One or Two person need to install the product.
- TIP -
- 15 -