Classic-Line
CO
fertilizer system Compact
2
Complete set with reusable 500 g CO
For CO
fertilization of aquaria of up to 250 litres.
2
- Instructions for use: please read carefully and keep in a safe place. -
Congratulations on purchasing this high-quality CO
fertilizer system from DENNERLE.
2
If used properly and treated with due care, this set will provide a simple, convenient and reliable means of supplying your aquarium with CO
most important fertilizer for aquarium plants - thus ensuring magnificent plant growth. CO
plants, in the slightly acidic to neutral range. DENNERLE wishes you hours of fun with your aquarium!
Safety rules for carbon dioxide (CO
) cylinders
2
• Use only to supply CO
to aquaria.
2
• CO
cylinders are highly pressurized. The following instructions should therefore be observed:
2
• Do not throw CO
cylinders. Store in cool conditions. Protect from sunlight and temperatures of over 50 °C.
2
• Use only when fitted with suitable pressure reducers for reusable CO
pressure reducer models Profi 2000, Compact, Professional and Exclusive.
• Cylinders must always be in an upright position when supplying CO
• Do not open CO
cylinders by force.
2
• Do not empty CO
cylinders completely. Refill only at authorised CO
2
before refilling.
• CO
gas is heavier than air and has a suffocating effect in high concentrations.
2
• Therefore, avoid breathing in CO
gas.
2
• Keep out of reach of children.
• Store CO
cylinders in well ventilated areas and not in cellars.
2
• Please note the following when transporting individual cylinders in vehicles: Secure to prevent from sliding and rolling around, as the valve
may otherwise incur damage and CO
gas may escape. Ensure adequate ventilation by means of an open window, by switching on the
2
blower, etc.
How the CO
fertilizer system
2
Compact works
The pressure reducer Compact automatically reduces the cylinder pres-
sure to an operating pressure in line with practical requirements. The
precision needle valve enables highly exact and very simple CO
ge. The CO
Micro-Perler ensures effective dissolving of the CO
2
aquarium water. The special CO
check valve protects the valuable pres-
2
sure reducer from any backflowing water.
The reusable 500 g CO
cylinder is particularly practical, supplying CO
2
over a long period before it needs replacing.
10
cylinder.
2
also serves to establish an ideal pH value for fish and
2
cylinders with W21.8 x 1/14" connecting thread, e.g. DENNERLE
2
. Secure cylinders to prevent them from falling over.
2
filling stations. Please note: Tare weight without cage. Remove cage
2
Overview of the
CO
fertilizer system Compact
2
dosa-
2
in the
2
2
Stand
Reusable 500 g CO
cylinder with cage (valve protection cage
2
CO
pressure reducer Compact with precision needle valve
2
CO
hose, 2 m
2
Micro-Perler CO
Special CO
check valve
2
GB
Set-up and connection
1. Connect the pressure reducer
1
• Place reusable CO
• Pull black protective cap off the needle
• Close the needle valve by turning in
2
, the
2
• Fit pressure reducer to CO
3
2. Fit check valve in CO
4
• Using a strong pair of scissors, cut a
• Unscrew both coupling rings from the
5
• Fit coupling rings to the ends of the
direction, i.e. in the direction of the long hose section!
• Screw coupling rings tight.
Note: It is also possible to fit the CO
the hose. However, please note that the shorter the distance is between
pressure reducer and check valve, the faster and simpler it will be to set
the number of bubbles.
3. Connect the CO
6
• Unscrew coupling ring from the hose
4. Connect the CO
• Rinse the Micro-Perler with warm tap
• Remove the screw cap and carefully
diffusor
2
7
cylinder in stand.
2
valve of the pressure reducer.
8
clockwise direction (if it is not yet clo-
sed). IMPORTANT: Tighten only gently!
cylinder
2
with coupling ring. Tighten coupling
ring firmly with 30 mm spanner.
Ensure that the washer is fitted correct-
Your CO
fertilizer system Compact is now ready for operation.
ly and that the sealing surfaces are
2
clean!
Setting the amount of CO
bubbles)
5. The right amount of CO
For magnificent plant growth, DENNERLE recommends a CO
hose
the aquarium of between 15 and 30 mg/l, whereby 20 to 25 mg/l
2
is ideal.
piece of approx. 10 cm in length from
The number of bubbles per minute required to achieve this level of CO
the CO
hose, ensuring that the cut is
depends on a variety of factors, such as the types of plants in the aqua-
2
straight.
rium, motion of the water, surface area/volume ratio, etc. The appro-
priate CO
supply level thus requires to be determined individually for
2
the specific aquarium concerned.
CO
check valve.
2
6. Determining the CO
Certain correlations apply between CO
hoses and slide hoses as far as they
will go onto the hose connectors of the
(CH) and pH value. The CO
accurately on the basis of the pH value and carbonate hardness.
check valve.
Suitable pH and CH tests are available from specialist retailers.
IMPORTANT: The arrow on the check
• Measure the carbonate hardness of your aquarium water.
valve must point in the CO
flow
2
• Read the pH value which corresponds to the desired CO
from the table. You should set this pH value +/- 0.1 by adjusting
the number of bubbles accordingly.
check valve at a different point in
Example: Carbonate hardness 4 °d, recommended pH 6.8 +/- 0.1.
2
Too much
CO
hose to the
KH 6,3 6,4 6,5 6,6 6,7 6,8 6,9 7,0 7,1 7,2 7,3 7,4 7,5
2
pressure reducer
2
32
25
3
48
38
4
64
51
connector of the pressure reducer, slide
5
80
63
on CO
hose and secure with coupling
2
6
96
76
ring.
7
111 89
8
127 101 80
Micro-Perler
2
9
143 114 90
10 159 126 100 80
water. Do not use detergent!
11 175 139 111 88
12 191 152 121 96
13 207 164 131 104 82
detach the ceramic diffusor together
14 223 177 141 112 89
with the washer (e.g. lift out using a
small screwdriver). Take care not to
damage the washer.
• Fill the Micro-Perler with water and rein-
sert the ceramic disc together with the
washer. Replace the screw cap.
• Plug the CO
supply hose onto the
2
hose connector.
• In the aquarium, select a spot with
good water circulation.
The spot should be as dark as possible
to prevent possible algae growth.
• Secure the Micro-Perler with the cera-
mic diffusor at the top as far down in
the aquarium as possible using the
suction cup.
(number of
2
2
level in
2
2
content in the aquarium
2
content, carbonate hardness
2
content in the water can be calculated
2
content
2
CO
correct
Not enough CO
2
2
2
pH value
20
16
13
10
8
6
5
4
3
3
2
30
24
19
15
12 10
8
6
5
4
3
40
32
25
20
16 13
10
7
6
5
4
50
40
32
25
20 16
13
10
8
6
5
60
48
38
30
24 19
15
12
10
8
6
70
56
44
35
28 22
18
14
11
9
7
64
51
40
32 25
20
16
13
10
8
72
57
45
36 29
23
18
14
11
9
63
50
40 32
25
20
16
13
10
70
55
44 35
28
22
18
14
11
76
60
48 38
30
24
19
15
12
65
52 41
33
26
21
16
13
70
56 44
35
28
22
18
14
11