Villager V 722 Mode D'emploi page 45

Villager
2.4 Operator controls (see Figure 1)
 Key switch, located on the dashboard (some models with a trip starter are not
equipped with key switch). The trip starter has 2 positions. By turning to "on",
the engine starts. Turning to "off" stops the engine. Models with electronic start
have 3 positions. When starting - turn to the "start" position, then remove your
hand.
 Accelerator command, located on the dashboard (panel). It is used to control
the speed of the engine. By moving the accelerator lever forward, the engine
speed will increase, and the accelerator lever will move backward - it will
reduce the engine speed. Some models with trip start are not equipped with a
key switch. Move the accelerator lever to the last position and then the engine
will be turned off.
 Blade drive lever: Push the blade lever to move the blade forward - into the on
position. Pull the blade drive lever back into the off position to stop the blades.
 Hand-operated lever for the operator presence: Lever for the presence of a
hand-operated operator:
 Brake control levers: While squeezing the handles of the control lever with both
hands, release the right and left neutral lock, then release the right and left
control lever - to move forward. When the control levers are released, the
mower will move straight ahead. To turn right, squeeze RH (right hand) control
lever. To turn left, squeeze the LH (left hand) control lever. Squeeze both
control levers, lock the right and left neutral lock, and the mower will stop.
 Locks for neutral are located at the bottom of the handle. They are used to lock
the steering levers while stopping.
 Gear shift lever: Used for speed control. When the device moves forward, if you
want to change from slow speed to high speed - push the gear shift lever
forward, then you can change the speed. When you switch from high to slower
speed - you must stop the unit, then change the speed.

Push the lever forwards / backwards with a short stroke of the lever (avoid
forcible pushing).
 Fuel shut-off valve: The fuel shut-off valve is used to switch off fuel - when the
unit is not used for several days, during transport to and from the place of
operation and when the device is parked inside the building.
14
V 722 (GB)