Mounting And Removing The Ac Adaptor Plug Head; Periodic Maintenance; Overload Protection; Protection Circuit - NSK iProphy mobile Mode D'emploi

8

Mounting and Removing the AC Adaptor Plug Head

When attaching the Plug Head to the Adaptor body, follow the procedure below.
1) Set the Plug Head on the Adaptor body ( ).
2) Slide the Plug Head to the direction of the arrow ( ).
To remove, push the Release Button shown on the right figure, then remove the Plug Head from the Adaptor
Body.
9

Periodic Maintenance

Perform periodic maintenance checks every three months according to the check sheet below. If any
abnormalities are found contact your Authorized NSK Dealer for repair.
Point to check
Head is loose
Rotation
10

Overload Protection

10-1 Protection circuit

When the product is operated under a load exceeding the allowable limit the protection circuit operates to
stop the motor and prevent a hazard or damage. The corresponding lamp flashes on the operation panel to
display the error.
Release Button
Adaptor Body
Check that the Head is firmly-fixed.
Rotate the motor handpiece and check for abnormalities such as abnormal rotation,
vibration, noise, and overheating.
Details
11
Plug Head
Fig. 5