Cata TD 3002 BK Instructions Pour L'installation, L'utilisation, L'entretien page 14

GB
THIS APPLIANCE IS DESIGNED FOR DOMESTIC USE
ONLY. THE MANUFACTURER SHALL NOT IN ANY
WAY BE HELD RESPONSIBLE FOR WHATEVER IN-
JURIES OR DAMAGES ARE CAUSED BY INCORRECT
INSTALLATION OR BY UNSUITABLE, WRONG OR
ABSURD USE.
The manufacturer declares that this product meets
all basic requirements regarding low-voltage elec-
trical equipment established in the 2006/95/EEC Di-
rective of 12 December 2006 and electro-magnetic
compatibility established in 2004/108/EEC Directive
of 15 December 2004.
User's Instructions
Installation
All operations relative to installation (electric con-
nection) should be carried out by skilled personnel in
conformity with the rules in force.
As for the specific instructions see part pertaining to
installer.
Use
TOUCH CONTROL HEATING ELEMENTS
Touch sensitive keys
All operations can be performed using touch sensitive
keys (capacitive sensors) located on the front of the
control board; each key has a corresponding display.
All actions are confirmed by an audible signal.
TOUCH CONTROL (Fig. 2)
1 ON / OFF
2 Minus -
3 Plus +
4 Double / Triple Circuit
5 Cooking zone
6 Setting level display
7 Dual circuit pilot light
8 Illuminated Segment Multiple Circuits
Installation
All operations relating to installation (electrical con-
nection) must be carried out by qualified personnel in
line with current regulations.
See the part reserved for fitters for specific instructions.
Switching the Touch Control on/off
After mains voltage is applied, the touch control
initialises for approximately one second before it is
ready for use.
All displays and LEDs flash for approximately one se-
cond after resetting. Once this period is complete, all
displays and LEDs switch off and the touch control is
in standby mode.
Press the ON/OFF (1) button to switch the touch con-
trol on.
The cooking zone displays indicate "0". If a cooking
zone is in "hot" (high temperature) mode, the display
will alternately indicate "H" and "0".
After switching the touch control on, it will remain
active for 20 seconds. If no cooking zone is selec-
ted, the touch control automatically switches back to
standby mode.
The touch control can only be switched on by pres-
sing the ON/OFF (1) button.
Pressing the ON/OFF (1) button at the same time as
other buttons will have no effect and the touch con-
trol will remain on standby.
The touch control can be switched off at any time
using the ON/OFF (1) button. This is even the case
when the control has been locked by the child safety
feature.
The ON/OFF (1) button always takes priority in the
switching off function.
Automatic off
Once switched on, the touch control automatica-
lly switches off after 20 seconds of inactivity. After
selecting a cooking zone, the automatic off time is
divided into 10 seconds, after which the zone is de-
selected and, after another 10 seconds, the touch
control switches off.
Switching a cooking zone on/off
If the touch control is switched on, the cooking zone
can be selected by pressing the button (5) of the co-
rresponding zone.
The display (6) of the zone selected lights up, while
the remaining displays are dimmed. if the cooking
zone is "hot", "H" and "0" are alternately displayed.
Press the PLUS (3) or MINUS (2) button to select a
setting and the zone will begin to heat up.
Once the cooking zone has been selected, the setting
can be selected by keeping the PLUS (3) button pres-
sed down. The setting begins at level 1 and increases