Marking - KERN CGB Séries Mode D'emploi

C Marking
The equipment complies with the following EC Directives and European Standards:
Council Directive 89/336/EEC "Electromagnetic compatibility (EMC)"
Applicable European Standards:
1. Electromagnetic Compatibility
1.1 Reference to 89/336/EWG: Official Journal of the European Communities,
No. 2001/C105/03
EN 61326-1 Electrical equipment for measurement, control and laboratory
Part 1:
Important Note:
The operator shall be responsible for any modifications to KERN equipment and must check
and, if necessary, correct these modifications. On request, KERN will provide
information on the minimum operating specifications (in accordance with the Standards
listed above for defined immunity to interference).
73/23/EEC "Electrical equipment designed for use within certain voltage limits"
Applicable European Standards:
EN 60950
Safety of information technology equipment including electrical business equipment
EN 61010
Safety requirements for electrical equipment for measurement, control and laboratory use
Part 1: General requirements
If you use electrical equipment in installations and under ambient conditions requiring
higher safety standards, you must comply with the provisions as specified in the applicable
regulations for installation in your country.
use EMC requirements
General requirements
Defined immunity to interference:
Industrial areas, continuous nonmonitored operation
Limitation of emmissions:
Residential areas, Class B
69