Westinghouse QK0322 Manuel De L'utilisateur page 10

Installation (continued)
INSTALLING THE SINK
NOTE:
Install the faucet according to the manufacturers instructions before this step.
Install the vanishing edge strainer according to the instructions before completing this step. See page 11.
TM
- Apply silicone sealant (not included) around the underside of the lip of the sink (A) on all four sides .
- Carefully lower the sink (A) into the counter, ensuring that the factory installed topmount clips (H) do not catch on the counter
edges .
- Slide each topmount clip (H) along the rails so that they are evenly spaced around the sink (A) .
- Swing the clamps on the topmount clips (H), and tighten the screws progressively (see tightening sequence below) until the sink
rim is flush with the counter. Check the alignment as you tighten so that the front of the sink (A) is parallel to the front of the
counter . Adjust and re-tighten if necessary . Do not over tighten .
- Wipe away any excess sealant with a rag .
A
H
A
SUPPLY LINES (NOT INCLUDED)
The supply lines, which connect the faucet to the household water system, are not supplied with this unit . They need to be purchased separately .
Follow the supply line manufacturer's instructions for proper installation .
6
9
10
3
Tightening sequence for clips
10
2 4
7
8
5 1