Operation; Troubleshooting; Maintenance - Westinghouse DELUXE QB025 Manuel De L'utilisateur

Operation

To use the new shower spa first turn on and adjust the temperature
on the existing shower valve then redirect the water to your new
shower spa using the diverter as shown in figure 20.
Use the selector switch, Fig . 21-23, to choose between the three
single use options:
1 . Shower head
2 . Body jets
3 . Handheld shower
You can also choose three combined use options by placing the
selector in between the icons, Fig . 24-26:
4 . The shower head and the handheld COMBINED
5 . The handheld shower and the body jets COMBINED
6 . The body jets and the shower head COMBINED
Adjust water temperature and pressure using your existing
shower valve .

Troubleshooting

- Make sure that the rubber washers (N), (U) are properly installed to prevent leaks .
- Make sure that you drill holes according to the instructions and that you secure the shower column (S) with the double-sided tape or on
the bottom bracket .
- If you find that water pressure or volume is low, clean the mesh gasket (C).
- If there is no water flow, check the brass connector (E) to make sure that it has not been installed incorrectly. Refer to Fig. 9 (on page 7)
of the installation guide .
- If the check valve (D) is installed correctly and there is still no water flow, take the shower column (S) off the wall, loosen the L-fitting
(L) and check that the restrictor (K) is not blocked by debris . Take the restrictor off, clean with water and reinstall .

Maintenance

- After use, rinse the shower column with water using the handheld shower to remove any soap deposits . Should water spots occur,
clean with a mild solution of vinegar and water followed by a thorough rinse .
- Use liquid soap, a general household cleaner, or a weak solution of vinegar and water for regular cleaning .
- Never use abrasive cleaners as they will scratch the finish.
Existing
shower
valve
Diverter
Tub spout
1
Selector
switch
Fig .21
4
Selector
switch
Fig .24
11
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
Existing
shower
valve
Fig .20
Selector
Selector
2 switch
switch
Fig .22 Fig .23
6
Selector
Selector
switch
switch
5
Fig .25 Fig .26
CONGLOMKB .COM
3