Final Installation; Shower Stall/Uneven Surfaces - Westinghouse DELUXE QB025 Manuel De L'utilisateur

Installation (continued)

FINAL INSTALLATION

- Install top cover (P) and the stainless cover (Q) on the shower
column (S), see Fig . 17 .
- Check to see that check valve (X) is pre-installed in handheld
shower head (W). Attach long flexible shower hose (Y) to the shower
column (S) and handheld shower head (W) with rubber washers (N)
and (C) as shown in figure 17.
NOTE:
Make sure that none of the hoses are bent or kinked after final installation.
Check water connections for proper flow; make sure there are no leaks. Do not
forget to use the rubber washers to prevent leaks from the connections. If you
find that the water pressure or volume is low, clean the mesh gasket (C).
IF YOU HAVE A SHOWER STALL OR TILES WITH AN ENEVEN SURFACE
- Measure the length of the gap between the top of the shower panel and the stall, see Fig . 18 .
- Cut both aluminum covers (DD) with scissors to desired length .
- Remove the paper backing from the aluminum covers (DD) then stick them on the gap from the panel to the wall .
- Stick the aluminum covers (DD) in place, see Fig . 19 .
Fig .18
QB025
Q
P
Fig .17
DD
DD
10 10
S
W
X
C
N
Y
DD
Fig .19