Mounting Parts / Instructions - Deskshaper Pro 2 Mode D'emploi

EN
ATTENTION: THE DESKSHAPER PRO 2 SHOULD NOT BE CHARGED
WITH MORE THAN 120KG!
PAY ATTENTION! READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN
SERIOUS BODILY INJURY.
MAINTENANCE
- Check regularly that all screws are properly tightened
- Clean the Deskshaper Pro 2 with a mild detergent.
- Use oil to keep the Deskshaper Pro 2 running smoothly.
- 1 year warranty
2. MOUNTING PARTS
3. INSTRUCTIONS
1. Mount the carrying handles(legs) to the frame of the DeskShaper Pro 2.
2. Open the DeskShaper Pro 2, and place the safety pen in the frame.
3. Place the left pedal on the left side and the right pedal on the right side
of the bike. Pay attention! If the pedals are mounted incorrectly, the
DeskShaper Pro 2 will be unusable.
4. Place the saddle on the seat post and tighten the bolt (A).
5. Slide the seat post on the top of the frame and tighten it with the
supplied bolt.
6. Set the desired resistance using the resistance button (B).
- 4 -