AEG Voxtel D210 Guide De Démarrage Rapide page 5

5.2 Cordless handset display (see P2)
The LCD display gives you information on the current status of the telephone.
#
Steady when the handset is in range of the base.
Flashes when out of range of the base or not registered to the base.
Steady when an intercom call is in progress.
Flashes when there is an incoming internal call.
Indicates a call is in progress on that handset.
Indicates that speakerphone is being used.
Indicates that the handset ringer is switched off.
Steady when an alarm is set.
Flashes when the alarm is sounding.
Indicates that the keypad is locked.
Indicates when you have a new Voice Mail message.
(This is a caller display service from the network operator.)
Indicates when the battery is fully charged.
Whole icon flashes when the battery is charging.
Internal block icon flashes when the battery is in final charging stage.
Indicates when the battery needs charging.
Flashes when low battery power level is detected.
Indicates when there are more characters or numbers in front of those being
displayed.
Indicates when there are more characters or numbers after those being displayed.
Left soft key function. Press to access the main menu.
Left soft key function. Press to confirm the current selection.
Indicates new call in call list.
Indicates more options available in lists, above or below.
Right soft key function. Press to start an intercom call.
Right soft key function. Press to go back to the previous menu (back) level or cancel
the current action.
Right soft key function. Press the alarm, or mute/unmute the microphone during
a call.
5.3 Corded Base Station
#
M1-M5 Direct memory keys
9 M1-M5
Press to call the number stored in the memory key.
Menu/OK
In idle mode: Press to access the main menu.
OK
10
In sub-menu mode: Press to confirm the selection.
In Redial List / Call Log: Press for sub-menu.
Meaning
Meaning
5