Install Custom Panel - Jenn-Air JDPSS245LX Instructions D'installation

5.
Attach custom panel
Vent duct on
applicable models
only
Align the studs on the custom wood panel to the keyhole
slots on the door assembly. Ensure that all 4 plastic studs are
engaged in the keyhole slots. Slide wood panel down until the
top surface of the wooden panel is flush with the top of the door.
7.

Install custom panel

Customer
supplied
panel
Using a Torx T15 screwdriver, install two #8 x 13/
in top corners to secure custom wood panel in place.
Wooden panel
assembly
Align top
edges
Drill through
this hole
13/ "
8
screw
" (long) screws
8
6.
Align top edges of panel to door
Remove 2 short screws
and replace with long
Customer
screws provided
supplied
panel
Open the door and align top edges. Use tape to mark a 3/32"
drill bit to gauge the hole depth of approximately 11/2" (38 mm).
Drill pilot holes into the top corners of the door, using hole in liner
as a guide.
8.
Remove the short screws
Remove 2 short screws
and replace with long
screws provided.
Remove the short screws (4
door panel. Use tape to mark a 3/32" drill bit to gauge the hole
depth of approximately 11/2" (38 mm). Drill 2 pilot holes using the
door liner hole as a guide into the panel. Install the 2 remaining
long screws.
11/2"
Align top
edges
Customer
supplied
panel
from top) on either side of the inner
th
Align top
edges
3