HK Audio Elements E 435 Mode D'emploi page 6

Install Kit E 435/E 435 A 1.2
6
5 Through Port
Speaker
Out This parallel output routes the line signal on to further
EA600 IL amps or other components such as active
7
monitors, monitor power amps, and the like via a cord
On
Off equipped with XLR connectors.
Power
8
6 Speaker Out
Mains
This Speakon NL4 output is not used in conjunction
with the Install Kit E 435 A.
7 Power Switch
When you switch the system's amp on, the Signal LED lights up red for
about five seconds and then changes to green, indicating the amp is
ready to operate.
8 Mains Input
Use the factory-included IEC cord to connect this socket to a wall outlet.
Note: The EA 600 IL is equipped with a V-Lock mains cord retainer. If you
use an optionally available Volex locking cord or another brand of cord
with a compatible design, you can lock the mains cord in place to prevent
accidental disconnection.
Caution! Make sure the local mains voltage matches the voltage
specified on the EA 600 IL. Connecting it to the wrong mains voltage
may destroy its electronic components.
2.3 E-Connect
The E-Connect audio bus/ mechanical coupler connects ELEMENTS
components without any additional loudspeaker cords.
The mid/high unit's E-Connect shaft has a detent button that locks in
place in the other unit's E-Connect sleeve. This coupler connects the
two components mechanically and the integrated bus routes the audio
signal through without requiring any outside cords. To separate the two
components, press the detent button and disengage the two modules.
6
3 Mounting
You will need these tools to proceed:
• Phillips head screwdriver
• 13 mm SW open-end wrench
• 5 mm hex key
Mounting units using a) up to four 5 mm
screws or b) one or two 8 mm screws
Now bolt the Install
The four holes let
Kit with the attached
you adjust the unit to
retaining plates (3) to
determine the desired
the mounting yokes.
distance from the
wall.
Screw the two
mounting brackets (2)
to the wall, spacing
them vertically to
match the number
and size of the
Elements module
you want to mount
(see page 3 for
dimensions).
Install Kit for passive
units only: Attach the
terminal block (9) with
the included screw
to the retaining plate
(3), which will later be
mounted on top.
Attach the retaining
plates (3) to the cover
and base of the Install
Kit using the M8 bolts
(8), washers (7) and
spacer sleeves.
Install Kit for passive
units only: Insert the
¼" (6.3 mm) plug into
the mid/high unit's
E-Connect port.
Align the Install Kit
horizontally to aim the
speakers, and then
tighten all screws.
Install Kit for passive
units only: Connect
a speaker cord (not
included) to the Install
Kit by way of the
terminal block.
Use the M3 screws
(4) to attach the cover
plates to the two
retaining plates.