Grid Preparation; Building In The Appliance Under A Worktop - Kuppersbusch IKU 169-0 Instructions De Montage

Grid preparation

Left door opening:
Remove the left side (A) of the grid cutting it from the
rear (see figure).
A
DO002/2
Right door opening:
Remove the right side (B) of the grid cutting it from
the rear (see figure).

Building in the appliance under a worktop

Dimensions of the recess
The dimensions of the recessed installation area
must correspond with those indicated in the figure.
DO013
Installation kit
1xB
1xA
1
32
B
2xC
1xK
18xI
To position the grid on the appliance proceed as
follows:
Apply the grid to the base of the appliance by
pushing on to the clasps (a) until they click.
a
DO001
1. Two cabinet securing brackets are supplied with
the installation pack. They need to be assembled
onto the cabinet prior to cabinet being pushed into
the Kitchen aperture.
- To fit these brackets remove the two screws at the
top left and right hand front corners of the cabinet.
- Position the two brackets as shown in the figure
and replace the two securing screws.
Left hand bracket
2
2. Push the appliance into place. The plug socket
necessary for connection of the appliance to the
electricity supply should be positioned, so that the
plug is not placed in the recess.
a
Right hand bracket