Zanussi ZRB632FW Notice D'utilisation page 7

Rear spacers and levelling
2
1
3
In the bag with the docu-
mentation, there are two
spacers which must be fit-
ted as shown in the figure.
Slacken the screws and in-
sert the spacer under the
screw head, then tighten
again the screws.
Removing the shelf holders
Your appliance is equipped with shelf retainers that
make it possible to secure the shelves during transpor-
tation.
To remove them proceed
as follows:
1. Move the shelf hold-
ers in the direction of
the arrow (A).
2. Raise the shelf from
the rear and push it
forward until it is
freed (B).
3. Remove the retainers
(C).
m1 m2
m5 m6
m4
m3
When placing the appli-
ance ensure that it stands
level. This can be ach-
ieved by two adjustable
feet at the bottom in front.
Electrical connection
Before plugging in, ensure that the voltage and frequen-
cy shown on the rating plate correspond to your domes-
tic power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the
domestic power supply socket is not earthed, connect
the appliance to a separate earth in compliance with cur-
rent regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Door reversibility
Warning! Before carrying out any operations,
remove the plug from the power socket.
Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during
the operations.
1
7