Eaton Metalux BCLED Instructions D'installation page 2

Installation Instructions - BCLED
2. Remove lens and endcap from fixture to access the
channel cover (Figure 1).
3. Remove channel cover from fixture assembly by
removing mounting screws from both ends of the
channel cover (Figure 2). After removing, DO NOT set
down with LEDs on channel cover.
LEDs should not be in contact with any surface.
N ote:
4. Wire according to regional and national electric code.
5. Install channel cover with screws provided and re-install
lens and endcap on fixture (Figure 3).
Figure 1.
2
EATON
IB519007EN Installation instructions
Figure 2.
Figure 3.