Assa Abloy OneSystem 309N Consignes De Sécurité page 19

! Warning!
Risk of injury and life-threatening danger due to dangerous installation work.
The machines and tasks required for complete installation entail a consider-
able risk of injury. The cutting and preparations in wood and metal may only be
carried out by skilled, qualified personnel who are trained in the necessary safety
measures for the avoidance of severe injury, particularly when handling milling
machines, saws, and drilling machines.
Unsuitable doors reduce personal safety and intrusion protection: Only ap-
proved and technically correct doors are suitable for installation of the OneSystem
Security Lock 309N / 319N. Prior to the installation of the OneSystem Security Lock
309N / 319N, the door must be checked to ensure that it is attached properly and
is not warped. The door must be approved for use of the OneSystem Security Lock
309N / 319N.
An incorrectly adjusted panic side can result in life-threatening danger and
risk of injury: After installing the lock, check whether the locked door can be
opened in the escape direction.
A
Attention!
Property damage caused by work on the door leaf: The lock must be removed
for all work on the door leaf, such as drilling or cutting.
Functional limitation due to faulty recess of the lock pocket: The lock pocket
must be created corresponding to the lock pocket dimensions. You must insert
the lock without using any force and screw it into place, so that is not subject to
mechanical stress.
Property damage after drilling through the lock: The lock is damaged by drill-
ing. You may only use existing holes drilled at the factory to attach door fittings.
The lock must be removed for any work on the door leaf, such as drilling or cut-
ting.
Damage from dirt: The lock is damaged by dirt. Prior to installation, the lock
pocket and all holes must be cleaned (by blowing out or vacuuming).
19
Information EN