Nuvo NV-P600 Fiche D'instructions page 7

STEP 1: Turn off the main power supply to the DIN rail enclosure.
STEP 2: Clip the power supply onto the DIN rail. (Fig. 2, Number 1)
STEP 3: Clip the amplifier(s) onto the DIN rail. (Fig. 2, Number 1)
Note: For best performance and ease of wiring, mount the amplifier(s) next to the power supply, on
the same DIN rail.
STEP 4: Connect the P600 to the P601. (Fig. 2, Number 3)
Note: Do not use the AUX/24 V connection for connecting to the P600. For future use only.
– Insert the exposed end of the cable into the P600 24 V (+) connection slot. Tighten the connection
screw.
– Insert the remaining exposed end of the cable into the P601 24 V/18 W (+) connection slot. Tighten
the connection screw.
– Repeat the wiring process for the P600 24 V (-) connection slot.
Note: Make sure the end of each cable is securely held under the appropriate screw connection.
– Repeat procedure to connect additional P600 units. Up to four P600 amplifiers can connect to one
P601 power supply unit.
7