Flange Installation; Wall Unit Mounting - Atag WO61 BM Serie Mode D'emploi Et Instructions D'installation

assembly
buiding in

flange installation

recirculation mode only
extraction
recirculation

wall unit mounting

GB 16
Install the flange supplied to the upper or rear exhaust outlet
as desired (bayonet fastening).
Make sure the charcoal filter is installed and the internal
Extraction/ Recirculation mode switch is set to "Recirculation".
For further details relating to the charcoal filter, please refer
to page 10.
1. Make the holes on the bottom of the cupboard (2),
using the drilling template (1). Make a hole for the
exhaust pipe (4) only if the hood is to be used in the
extraction mode (3).
2. From inside the cupboard, insert the 4 supplied screws
(5) and tighten them in the appropriate holes on the
appliance.