What Should I Do If - Atag WO61 BM Serie Mode D'emploi Et Instructions D'installation

faults

what should I do if...

If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first. Phone the service department if the advice
given below does not work.
attention:
Disconnect the appliance from the mains before starting the repair, preferably by
removing the plug from the socket or setting the main switch to zero.
fault
Lighting is not functioning.
Extractor hood makes a
noise.
No extraction.
cause
Light bulb defective.
Discharge too long or too
many bends in the duct.
Motor defective.
Motor or controls defective.
Connection cable defective.
solution
Disconnect the hood from
the electricity.
Warning! Prior to touching
the light bulbs ensure they
are cooled down.
Remove the grease filters.
This gives access to the
light bulbs. Unscrew the
bulb from the fitting and
replace it with a new 40 W
bulb.
Change the discharge
ducting (see installation
guide).
Phone the service
department.
Phone the service
department.
Phone the service
department.
GB 11