ARIETE Stiromatic NO STOP R5 Mode D'emploi page 10

• Before plugging the appliance into the mains socket, ensure that the voltage shown on the rating plate matches the local
voltage supply.
• Always connect the iron to an earthed socket.
• DO NOT IMMERSE THE APPLIANCE IN WATER OR OTHER LIQuIDS.
• Do not start ironing if your hands are wet or if you are barefoot.
• Fill up the tank with water before starting up the appliance. Be sure to unplug the appliance before pouring water into the
tank.
• Turn on the appliance only when it is in working position.
• The appliance may give out a little smoke when used for the first time; This transitory effect is perfectly normal and is due
to the fact that some of components have been slightly lubricated.
• During use, rest the appliance onto a horizontal surface.
• Never leave the appliance unattended when it is connected to the power supply.
• The appliance must be used and rested on a stable surface.
• When placing the iron on its stand, ensure that the surface on which the stand is placed is stable.
• Before leaving the iron unattended, even for a short time, turn off the appliance, always unplug it and place it on support
base (L).
• Pressing the steam button before the boiler has reached the optimum temperature or the iron has heated up may cause
water to leak from the steam holes.
• The appliance is not to be used if it has been dropped, if there are visible sign of damage, faults or suspected defects after
dropping or if it is leaking water. Immediately unplug it from the socket-outlet. Never operate the appliance if defective.
To prevent any accident, all repairs, including the replacement of the power cord, must be carried out by an Authorised
Service Centre or, in any case, by qualified personnel. Otherwise, the warranty may be revoked.
• Never try to iron garments being worn.
• Do not touch the metal parts of the iron when in operation and for several minutes after it is turned off since it could cause
burns.
• Do not aim the jet of steam towards parts of the body or pets.
• Remove any labels and protections from the soleplate before using the appliance for the first time.
• Always unwind the power cord before use.
• The use of extensions not approved by the manufacturer can result in damage to property and personal injury.
• using the appliance with no water in the tank may damage the pump.
• Do not use sparkling (carbonated) water. If your water supply is very hard, we suggest you use demineralised water
instead.
• When the iron is hot, do not rest it onto the connecting cable or the power cord. Take special care in ensuring that the cable
and the cord do not come into contact with the soleplate when it is hot.
• Do not pull the power cord to unplug the appliance.
• The appliance must only be cleaned with a soft, slightly damped, cloth after unplugging the iron and allowing all its parts
to cool down. Never use solvents which may damage the plastic parts.
• Clean the boiler at least every two months so as to eliminate any residue of lime that could jeopardize proper
operation of the appliance. remember to put 400 cc of water back into the boiler before replacing the cap.
• Do not pour vinegar, descalers or other scented substances into the tank; otherwise, the warranty may be revoked.
• Do not wrap the power cord around the soleplate when the iron is hot.
• Do not put the soleplate in contact with metal surfaces.
• Turn off the iron before putting it away, pressing the switch (E). Always unplug the power cord, wait for the iron to cool
down and empty the tank completely.
• Do not expose the appliance to atmospheric agents (rain, sun...).
save these instructions for future reference.
•
10
Danger due to electricity
Danger of damage originating from other causes
Warning of burns
Warning – material damage