Marshalltown Bullet SHARPSHOOTER PRO Manuel D'utilisation page 6

Firmly lift the friction-fit fence to remove it from the table and press back down in the appropriate 45-degree
position.
NOTE: This image is for the Marksman. Your shear may look slightly different.
FLOPPY MATERIALS
When cutting floppy materials, flip the anvil: Remove
anvil and blade-stop using a 4mm or 5/32" hex key.
Reinstall with flat side up instead of bevel. This makes
fibrous and floppy materials (examples: cove base, thin
vinyl plank) cut more easily.
For Kevlar® fiber reinforced materials (example:
rubber belting), put flat side of anvil up above, but also
remove plastic blade-stop.
6 of 14
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
45 DEGREE CUTS
ANVIL
DOUBLE CUTTING
Most materials shear very well with just one cut.
However, some brands of fiber cement siding and
other products may require cutting twice to produce
a better cut. Simply make your first cut 1/8" to 1/4" (3 to
6mm) longer than your mark, then go back and make
your second cut on your mark. This is very useful to
create a cleaner cut when a trim molding or transition
cannot be used to cover your cut end.
WS2550