Removing The Snow Plough; Removing The Cover; Controls; Lift Arm - Viking ASS 125 Manuel D'utilisation

● Insert the cotter pin (2) through the bore
in the centring pin as far as it will go.
Close the clamp on the cotter pin (2).

6.3 Removing the snow plough

Risk of injury!
The weight must be taken into
consideration before lifting the
snow plough (A). The weight of the
entire snow plough assembly is
36 kg.
For safety reasons, the snow
plough should only be lifted with the
help of a second person.
After removal, set the snow plough
down and ensure that it cannot fall
over.
● Stop the engine.
(See instruction manual of the ride-on
mower)
● Engage the parking brake.
(See instruction manual of the ride-on
mower)
● Swivel the coupling triangle to the
central position. ( 7.3)
● Lower the coupling triangle completely.
( 7.1)
Step 1:
● Open the clamp on the cotter pin (2).
Detach and remove the cotter pin (2).
Step 2:
● Lift the snow plough assembly (A) and
remove from the coupling triangle.
Set the snow plough (A) down safely.
● If necessary, attach the cotter pin to the
centring pin properly (clamp on cotter
pin must be closed).
26
Avoid damage to the machine.
When installing the mowing deck,
always remove the cover and install
the discharge chute. The mowing
deck may only be used with the
discharge chute installed.
5

6.4 Removing the cover

Note:
On the models
MT 5097/ G/ C/ K/ Z, MT 5112 Z,
MT 6112 C/ ZL, and MT
6127 ZL/ KL, the discharge chute
must be installed after the cover is
removed.
● Unscrew and remove the nuts (1).
● Detach and remove the cover (2) from
the screws (3).
● MT 5097/ G/ C/ K/ Z, MT 5112 Z,
MT 6112 C/ ZL and MT 6127 ZL:
Install the discharge chute.
(See instruction manual of the ride-on
mower)

7. Controls

7.1 Lift arm

Danger of crushing!
Only operate the lift arm from the
6
driver's seat of the ride-on mower.
Keep others away from the direct
vicinity when lowering the snow
plough.
Actuate the lift arm only when the
ride-on mower is at a complete
standstill.
Always hold the lift arm firmly when
actuating it (lifting or lowering) and
guide it until it reaches the working
position or transport position.
The snow plough has two positions - the
transport position and the working
position.
When the snow plough is in the transport
position, it is raised and is not in contact
with the ground.
When the snow plough is in the working
position, its entire weight is on the ground.
The position of the snow plough can be
changed conveniently from the driver's
seat using the lift arm.
Lifting the snow plough:
● Push the lift arm (1) outwards slightly
(away from the ride-on mower) and hold
it.
Press the lift arm (1) downwards and
attach it securely in the retaining clip
(2).
Release the lift arm (1) slowly and
carefully.
Lowering the snow plough:
7
0478 907 9918 B - EN