TAD D1000TX Mode D'emploi page 21

Symptom
No sound is produced ' The computer is set to a different input
for USB input.
' The computer's mute function is ON.
' Connections are wrong.
' The unit is not detected by the computer.
The file format, OS, or playback software is not
supported.
The USB input's Depending on the computer's setting, the
sampling rate is always sampling rate may remain the same even when
the same. playback files have different sampling rates.
Computer sounds Depending on computer settings, the
(other than music computer's boot-up beeps or error sounds may
sounds) are audible be audible from the unit.
from the USB input.
When input is set to When not set to USB input, the computer
something other than doesn't recognize the unit.
USB, the unit can't
play music files on the
computer's playback
software.
The power turns off by If the ECO (power-saving) mode is turned ON,
itself. the unit will automatically enter standby mode
if no operation is performed on the unit for 30
minutes.
Display is not visible. The display viewing angle is within 45° to right/
left from the front of the unit.
The unit is set to display off.
The remote control ' The remote control's batteries are expended.
doesn't work. ' The remote control is being used too far
' Angle is bad.
' Line of sight to the main unit is blocked.
' Strong light from a fluorescent lamp or
Static electricity or other external influences may cause malfunctioning of this unit. In this case, unplug the power cord and
then plug back in. This will usually reset the unit for proper operation. If this does not correct the problem, please consult your
dealer.
This unit is designed as a consumer audio product (audio/video component). It is not designed for long continuous
use as a commercial BGM source, nor for use in automobiles, ships, or outdoors.
Possible cause
component.
away from the main unit.
other light source is directly striking the
signal receiver.
Remedy
Check the computer's sound settings.
' After the unit is connected to the computer,
if the unit's input is switched to USB, the
computer's sound setting may switch to
a different input component. In this case,
reselect TAD-USB1 ver2 or TAD-USB2 ver2 as
the input.
' Check the connections again.
Confirm that the OS, software, and file sampling
rate are supported (page 18).
Check the computer settings.
Check the computer settings.
Switch to USB input, and reset the computer's
sound setting to TAD-USB1 ver2 or TAD-USB2
ver2.
Set the ECO (power-saving) mode to OFF
(page 19).
View the display from immediately in front of the
unit.
Press the DISP OFF button on the main unit (or
the DISPLAY OFF button on remote control) to
cancel the display off function.
' Replace the batteries with new ones.
' Use the remote control from within a distance
of 7 meters (23 ft.), and within an 30° arc to
right/left of the unit's front panel.
' Remove obstacles between the main unit
and remote control, or change to a different
location when operating the remote control.
' Readjust the position of lamps or other light
sources so that strong light does not strike the
signal receiver.
21