TAD D1000TX Mode D'emploi page 16

When connecting with a power amplifier
1. Turn on power to both the unit
and computer.
2. Switch the unit's input to U1.
3. Using a USB cable, connect
the computer and unit; when
this is done the proper driver
will be automatically installed
(page 18).
BALANCED
output connector
(XLR-3-31 equivalent)
1
3
1: Ground
2: Hot
3: Cold
Power amplifier with balanced input connectors
Line output volume
As the line output volume is mounted, a simple system can be configured only by connecting a power amplifier.
About the balance/unbalance line output level
' The initial value for the line output is set at 30. For details, refer to Adjust the sound volume on page 18.
WARNING
' When using the volume function and connecting directly to a power amplifier (without using a pre-amplifier), be sure to
make the connection only after setting the volume to "0" (zero). If the connection is made with the volume set to a large
value, an excessive sound volume is generated to damage the speaker or your hearing ability.
16
Computer with USB port
R L R L
BALANCED UNBALANCED
2
INPUT R INPUT L 12 V AUTO
BALANCED UNBALANCED UNBALANCED BALANCED TRIGGER IN POWER DOWN
UNBALANCED
BALANCED
ON OFF
SPEAKER R SPEAKER L
BI-AMP
STEREO
AC IN
Component with digital output connector
USB XLR COAXIAL OPT 12 V XLR COAXIAL
D1 D2 D3 D4 TRIGGER
OUT
DIGITAL INPUT
R L
Power amplifier with unbalanced input connectors
In case of a power amplifier with a 12 V
trigger input terminal.
Commercially available 3.5Φ monaural
pin cable (without resistance)
Power cord
(supplied)
AC IN
Component with digital
input connector
To AC
Power outlet