Installation And Connections; Installation; Connecting Up - TAD D1000TX Mode D'emploi

INSTALLATION AND CONNECTIONS

Installation

WARNING
' Install the unit in a flat, level and stable location that provides fully sufficient strength to support the unit's weight, since
damage or personal injury may occur if the unit falls from its installation. When installing on a bookshelf or similar
structure, be sure to confirm first that the shelf structure has sufficient strength.
' Never set other items on top of the unit, or cover the unit with cloths or sheets, since heat dispersion may be impaired,
leading to unnatural heat buildup and potential damage.
CAUTION
' When installing the unit, allow a minimum 10 cm clearance from adjacent walls or barriers. In order to facilitate heat
dispersion, the unit should be installed at some distance from other electric components. When installing the unit
on a rack, a minimum of 10 cm clearance should be provided above, behind, and to the sides of the unit. Leaving
insufficient ventilation space around the unit may lead to excessive heat buildup and the potential for fire.
' Never install the unit on a rug, cushion or other soft surface, or in a narrow location that may interfere with natural air
flow around the unit.
' The inside of this device comprises a round-type spike structure. To allow the insulator function to be fully fulfilled,
the protrusion at the lower center of the insulator, which is not fixed, slightly moves. Note that this unfixed protrusion
is not damaged or broken but normal.

Connecting up

CAUTION
' Do not turn on the power switch to the unit or the other components until all connections have been completed.
' When connecting components or changing connections, always set the power switch to OFF and disconnect the power
cord from its AC outlet. When making connections, connect the power cord last.
1. Connect other components.
2. Connect the supplied power cord to the unit's AC IN connector.
3. Connect the power cord to a standard electrical outlet.
When connecting
a device equipped
with the pre-
amplification
feature
Note
About the balance/unbalance line output level
' The initial value for the line output is set at 30. For details, refer to To fix the line output levels at their maximum on page 18.
Computer with USB port
1. Turn on power to both the unit
and computer.
2. Switch the unit's input to U1.
3. Using a USB cable, connect
the computer and unit; when
this is done the proper driver
will be automatically installed
(page 18).
BALANCED R L
BALANCED
output connector
(XLR-3-31 equivalent)
1
2
3
1: Ground
2: Hot
3: Cold
Pre-Amplifier with balanced input connectors
Component with digital output connector
USB XLR COAXIAL OPT XLR COAXIAL
12 V
D1 D2 D3 D4 TRIGGER
OUT
DIGITAL INPUT
R L
UNBALANCED
R L
Pre-Amplifier with unbalanced input connectors
In case of a power amplifier with a 12 V
trigger input terminal.
Commercially available 3.5Φ monaural
pin cable (without resistance)
Power cord
(supplied)
AC IN
To AC
Power outlet
Component with digital
input connector
15