Main Unit Rear Panel - TAD D1000TX Mode D'emploi

Main unit rear panel

R L
BALANCED UNBALANCED
1
1 ANALOG OUTPUT connectors
Connect to Pre-Amplifier.
• BALANCED XLR type
• UNBALANCED RCA type
2 USB port
Use to connect a USB cable to computer.
3 DIGITAL INPUT connectors
Connect to a component equipped with a digital output
connector.
• XLR (balanced) type (D1)
• COAXIAL type (D2, D3)
• OPT (optical) type (D4)
4 12 V TRIGGER OUT connector
If this device is connected with an external device with
a 12V trigger input terminal, the external device can
be switched over between "Power ON" and "Standby"
by switching over this device between "Power ON" and
"Standby."
Connector: Ø 3.5 mm monaural mini-jack
Operating conditions:
When this device is turned ON, "H" is output. When this
device is in the standby mode, "L" is output.
USB XLR COAXIAL
D1 D2
DIGITAL INPUT
R L
2 3
OPT XLR COAXIAL
12 V
D3 D4 TRIGGER
OUT
4 5
5 DIGITAL OUTPUT connectors
Connect to a component equipped with a digital input
connector.
• XLR (balanced) type
• COAXIAL type
Note
' Digital output is disabled when playing SACD.
' When playing a CD, the signals are output at 44.1 kHz/
16 bits.
6 AC IN connector
Connect the supplied power cord here.
AC IN
6
13