Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Display Functions
"VHF"
Indicates that the 2m VHF band
136...174 MHz) is selected.
"AIR"
Indicates that the AIR band 108-
136 MHz in AM is selected.
"WFM"
Indicates that the wideband FM band (broadcast radio) 87.5-108 MHz is selected.
"CB10"
Indicates that the CB radio band with 10 kHz steps is selected.
"VLB"
Indicates that the VHF low band (the 4 m band) is selected.
"PRI"
Indicates that the Priority channel is selected.
"AM"
Indicates that the AM modulation mode is selected.
"
"
Indicates the "key beep" on selected.
"SKIP"
Indicates that the selected frequency is locked out from scanning and
"skipped" during search or scan mode.
Indicates that the keylock function is selected.
"DLY"
Indicates that the "SCAN start DELAY" function is selected.
"HOLD"
( = " STOP ") Indicates that the "SCAN STOP HOLD" is selected.
"VOL"
Indicates the "VOLUME CONTROL" function selected.
"SQ"
Indicates the "SQUELCH CONTROL" function selected.
"
"
Indicates the battery condition. Full segment means a fully charged battery. If the
batteries become discharged, the indicator will start to twinkle and a beep sound can
be heard every 5 seconds.
" BUSY"
Indicates that a signal is being received.
"
LCD. When receiving a signal, the meter will indicate how strong the signal is. A weak
signal will be indicated by one or two segments, while a very strong signal will have 8
to 10 segments.
" FC"
Indicates that the Function Key has been pressed and the radio is in
the second key function level.
" MR"
Indicates that a memorized channel is selected. The channel number
will appear in the small 7 segment channel number display (up to 200
memory locations).
" The receiver shows a ten segment incoming signal meter on the
Publicité
Chapitres
Table des Matières
