Maintenance And Care; Technical Data - Matrix AGBF 7,2 Li-2 Traduction De La Notice Originale

and towards the lawn.
In order to start the machine, activate the
On/Off switch (16) and the switch lock (20)
simultaneously afterwards. (B15)
In order to switch off, release the On/Off switch
(16).
Bush and shrub trimming
CAUTION: The telescopic guide handle
may not be mounted when using the
device as shrub trimmer.
In order to switch the device on, push the switch
lock (4) to the right or left of the handle inwards
and press the On/Off switch (3).
In order to switch off, release the On/Off switch
(3). Only use the shrub trimmer to cut back
smaller bushes or shrubs.
Maximum branch thickness with fully charged
battery 5 mm
Fatigue-free operation
Slightly tilt the shrub trimmer in the direction
of the bushes to be cut to ensure a fatigue-free
operation. Trim the sides first, work from the
bottom to the top and continue with the upper
side. Make sure to check for possible foreign
objects in and near the hedge and remove them.
If fatigue sets in, take breaks from the work.

10. Maintenance and care

- Close the device and remove the battery before
maintenance and cleaning it.
- Thoroughly clean the device before and after
each use. However, do not use running water,
especially not in combination with high pressure.
Also remove the dirt between the upper and
lower blade.
22
- The blades should always be sharp. Always
repair any notches caused by stones, for example,
immediately. Applying a little bit of oil to the
blade will improve the cutting performance.
- The storage location must be dry, frost-
protected and inaccessible to children.
- Regularly check and maintain the device.
Only have it repaired by a certified expert.
- If not in use, the device is to be stored out of the
reach of children.

11. Technical data

Lithium battery:
Speed:
Grass shear
Cutting width:
Grass trimmer
Cutting length:
Charger
Mains voltage 100-240 V~/ 50-60 Hz; 8 W
Output voltage:
Charge current:
Charging time:
Sound and vibration
Sound and vibration values were measured in
accordance to EN 60745.
Grass Trimmer
Without pole
L sound pressure level 72,37 dB(A)
pA
K uncertainty 3 dB(A)
pA
L sound power level 80,85 dB(A)
WA
K uncertainty 3 dB(A)
WA
With pole
L sound pressure level 70,30 dB(A)
pA
K uncertainty 3 dB(A)
pA
L sound power level 80,03 dB(A)
WA
K uncertainty 3 dB(A)
WA
7.2 V DC/1.3 Ah
-1
1000 min
100 mm
170 mm
9 V DC
400 mA
3-5 h