REV.0-11/10
Check daily
!
Do not alter the primary conditions of regulation and
do not touch the sealed parts.
STARTING THE ENGINE
1. Turn the fuel cock (87) to OPEN.
CLOSE
OPEN
2. Switch the choke control (66) to CLOSE
CLOSE
OPEN
N.B.: Do not use the air valve if the motor is hot or the
air temperature is too high.
3. Turn the engine switch (28) to the ON position
Lightly pull the start-up knob (73) until meeting resi-
stance, then pull decisively.
STARTER GRIP
Engine starting and stopping
NOTE
CLOSE
OPEN
FUEL VALVE
CHOKE LEVER
ENGINE SWITCH
ATTENTION:
Allow the start-up knob to re-enter slowly, avoiding ha-
ving it knock against the motor and thereby damaging
the start-up system.
STOPPING THE ENGINE
To stop the engine in an emergency, simply turn the
engine switch to the OFF position.
Under normal conditions, use the following procedure:
1) stop to draw single-phase current from the auxiliary
sockets
2) Wait for a few minutes to allow the machine to cool
off, take however into consideration the prescriptions
given in the engine use manual.
3) Turn the engine switch to the OFF position.
4) Shut the gasoline cock.
CLOSE
OPEN
CAUTION
!
RUNNING-IN
During the first 50 hours of operation, do not use more
than 60% of the maximum output power of the unit and
check the oil level frequently, in any case please stick
to the rules given in the engine use manual.
GE 2500 SR FAMILY
ENGINE SWITCH
CLOSE
OPEN
FUEL VALVE
M
26