Introduction; Symbols; Safety; Intended Use - Renfert 2200 5000 Mode D'emploi

1. Introduction

EN
1.1

Symbols

In the instructions for use and on the unit itself you will find these symbols with the following meanings:
Danger
This indicates a direct risk of injury. Consult accompanying documents!
Electrical current
This indicates a risk of hazard due to an electrical current.
Attention
Disregarding this warning may result in damage to equipment.
Note
This provides the operator with useful information to improve and ease use.
The device complies with the requirements of the applicable EU directives.
The device is subject to the EU directive 2002/96/EG (WEEE directive).
► List, particular attention should be paid
• List
- Subsection numbering
⇒ Instructions / appropriate action / input / operational sequence:
You will be asked to carry out the action in a specified order.
♦ Result of an action / reaction of the device / reaction of the program:
The unit or program reacts as a result of your actions or when a specific incident occurs.
Other symbols are explained as they occur.

2. Safety

2.1

Intended Use

The product is designed for use on the Renfert Mobiloscope only.
It may only be operated with the mains adapter supplied.
2.2

Improper Use

The product may not be used for general lighting applications.
It may not be built into other units or housings.
The product must not be supplied with power with a different mains adapter.
2.3

Ambient Conditions for Safe Operation

The device may only be operated:
• Indoors,
• Up to an altitude of 2,000 m above sea level,
• At an ambient temperature of between 5 - 35 ºC [41 - 95 ºF]
• At a maximum relative humidity of 80 % at 31ºC [87.8 ºF], dropping to a linear of up to 50 %
relative humidity at 35 ºC [95 ºF],
• With mains power where the voltage fluctuations do not exceed 10 % of the nominal value,
• Under contamination level 2 conditions,
• Under over-voltage category II conditions.
- 2 -