Hardware Setup; Important Notice - Diamond WPCTVPRO Mode D'emploi

Hardware setup

IMPORTANT NOTICE:

The WPCTVPRO Transmitter
and Receiver must be placed with in line of sight and in the
same room. This device uses Ultra Wide Band Samsung
wireless solution and cannot transmit or receive through
walls or other large obstructions.
Connect the HDMI cable to the WPCTVPRO base receiver and then connect the other end of the HDMI
cable to your HDTV/Projector. Alternately you can use the VGA port of your display or projector does
not support HDMI. VGA cable is not included
Plug the supplied power adapter into an AC outlet and then connect the plug into the WPCTVPRO base
receiver.
Proceed with the Software Driver installation. Do not plug the USB PC adapter until instructed to
below. The following instructions are for Windows 8, 8.1 and Windows 7.
Installing the WPCTVPRO DisplayLink USB Graphics Software