Conceptronic CNAPT120 Mode D'emploi page 4

ENGLISH
Charging your Notebook
Before you can connect the notebook charger to your notebook, you have to pick the correct charging tip
and set the correct voltage. You can find the correct voltage for your notebook on the bottom of your
notebook, or on the original power supply.
A list of compatible notebooks can be found in the FAQ section of the Conceptronic website.
• Select the correct tip for your notebook from the included 15 tips (Appendix B).
• Connect the correct tip for your notebook to the output cable of the notebook charger.
• Connect the power cable to the notebook charger and to a free wall socket. The LED of the default set
voltage will light up on the top of the notebook charger.
• Use the switch on the side of the notebook charger to set the
correct voltage for your notebook. You can choose between
15 Volt, 16 Volt, 18 Volt, 19 Volt, 20 Volt, 22 Volt and 24 Volt.
When changing the voltage, the corresponding LED on the top of
the notebook charger will light up.
Note: Make sure you set the correct voltage! If you use the wrong
voltage, you can damage your notebook!
• Connect the output cable with the chosen notebook tip to your
notebook. Your notebook will now be charged by the notebook
charger.
Note: The build-in fan will only turn on when the load of the notebook charger is very high, or when the
notebook charger reaches a high temperature.
Charging your USB device
The notebook charger also has a built-in USB charger for USB devices, like MP3 players, mobile phones or
other USB devices which can be charged through USB.
This USB charger has a standard output of 5 Volt and will not change when you change the notebook
charging voltage.
• Connect the power cable to the notebook charger and to a free wall socket.
• Connect your USB device to the USB port of the notebook charger.
Your USB device will now be charged by the notebook charger.
3. Usage
4