Kohler K-1188-C1 Guide Du Propriétaire page 7

Your Overflowing Bath (cont.)
NOTE: Exercise caution if you walk or move around in the bathing well. Plastic surfaces are inherently
slippery when wet.
Slowly enter the bathing well, then press the pump control switch to start the pump/motor and
begin operation.
As the pump/motor turns on and water begins to circulate, the green light on the pump control
switch will change to solid green and will stay on as long as the overflowing bath is running.
Press the pump control switch again to turn off the overflowing bath. The green light in the pump
control switch will automatically start to blink until the overflowing bath is drained below the
overflow channel sensors, or is restarted.
After approximately 20 minutes of continuous operation, a built-in timer will automatically stop the
pump/motor.
Chromatherapy Light Operation
If the chromatherapy lights are turned off, press the light control switch (located opposite of the
pump control switch). The chromatherapy lights will begin to cycle through each of the colors
(sweep mode). The light control switch flashes blue in the sweep mode.
If desired, press the light control switch to lock in one constant color. The light control switch is a
constant blue in this mode.
Press the light control button to turn the chromatherapy lights off.
Kohler Co. 7 1019731-5-D