Electrical; For 230 Volt Machines Only - GBC Magnapunch 2.0 Manuel D'installation Et D'utilisation

d s C
ie et aUtions
CAUTIONS:
• Possible pinch point hazard. When installing Die
Sets into your Magnapunch 2.0, always keep
fingers and body parts out of the Magnapunch
2.0's Die Set slot and away from all areas of the
Die Set except for the finger groove in the Die
Set's handle. Failure to observe these precautions
may result in injury.
• Possible Die Set damage. Make certain that all
punch pins are fully and properly seated in the Die
Set before inserting the Die Set. Failure to ensure
that all punch pins are fully seated could result in
damage to the Die Set and Magnapunch 2.0.
e
leCtRiCal
The Magnapunch 2.0 should be connected only to
a source of power as indicated in these instructions
and on the nomenclature plate located on the rear of
the Magnapunch 2.0. Contact an electrician should
the attachment plug provided with the Magnapunch
2.0 not match the receptacles at your location.
WARNING: Do not attempt to service or repair
the Magnapunch 2.0. Failure to observe this warning
could result severe personal injury or death.
Make sure the power switch is in the Off position
when the Magnapunch 2.0 is not in use.
Page 1-2
Magnapunch 2.0 – Installation and Operating Instructions
Disconnect the plug from the receptacle and contact
your dealer or distributor, or GBC Technical Service
when one or more of the following has occurred.
• The power supply cord or attachment plug is
damaged.
• Liquid has been spilled into the Magnapunch
2.0.
• The Magnapunch 2.0 is malfunctioning.
• The Magnapunch 2.0 does not operate as
described in these instructions.
CAUTION: The receptacle must be located
near the Magnapunch 2.0 and must be easily
accessible.
Disconnect the attachment plug from the receptacle
to which it is connected and keep the power
supply cord in your possession while moving the
Magnapunch 2.0.
f 230 v
oR
CAUTION: When choosing a detachable
line cord for use with your Magnapunch 2.0, always
observe the following.
• The cordset consists of three parts;
attachment plug, cordage, and appliance
inlet. Each of these components must have
European regulatory approvals for safety.
• The following minimum electrical ratings
for the specific cordset are published for
safety purposes. Do not use cordsets that
do not meet the following minimum electrical
requirements.
Plug: 10 amperes, 250 volts, 50/60 Hz,
European safety approved.
Cordage: Type HO5VV-F3G0.75, harmonized
( HAR
approved to appropriate European standard.
Note, HAR may be substituted by the approval
mark of the European Safety agency which
approved the cordage. An example would be
VDE
Appliance Connector: 10 amperes, 250 volts,
50/60 Hz, European safety approved, Type IEC
320.
The cordset shall not exceed 3 meters in
length. A cordset with component electrical
ratings greater than the minimum specified
electrical ratings may be substituted.
M o
olt aChines nly
). The symbols indicate cordage
.