Hoover HBP60 Prescriptions De Montage Et Mode D'emploi page 11

ternal exhaust (suction) type.
— The best performances are obtained
with short pipes (max. 4 m) and with few
curves.
Maintenance
Before performing any maintenance ope-
ration, disconnect the hood from the
electricity.
Grease filter
The grease filter traps the suspended grease
particles.
There are three different types of grease
filter:
1) Synthetic grease filter - washable (10/
15 mm thick): With normal domestic use,
the synthetic filter should be washed in
lukewarm water at least every 30 days.
Do not wring after washing.
2) Special paper filter - not washable
(approx. 1 mm thick with pink diagonal
stripes): The filter should be replaced
when the stripes become visible through
the holes of the grid.
3) Filters in layers of stretched aluminium:
Should be washed in the dishwasher or
in soapy water at least once every 30
days of normal use or at more or less
frequent intervals, depending on the use
of the appliance.
Let the filter dry thoroughly before
refitting it.
To remove the grease filters, proceed as
follows:
To remove the filter, proceed as follows:
a) Remove the grid (fig.3).
b) Extract the filter after removing clips V
(fig.15).
c) It is advisable to clean the grill whenever
the filter is washed.
d) Ensure that the grill is completely dry
before refitting it.
Carbon Filter
The active carbon filter serves to dissolve
odours from food that is cooking.
It cannot be washed or regenerated.
GB
Replace it every four months.
To dismount the carbon filters refer to what
is described on paragraph "Internal recy-
cling version".
Attention
Failure to observe the rules for cleaning the
appliance and changing and cleaning the
filters may cause fires. Therefore, we recom-
mend observing these instructions.
Replacement of lamps
Disconnect the appliance from the mains.
Remove the metal filters.
For the lighting, use a normal commercially
obtainable lamp of 40 W (E 14).
— Before calling for technical assistance
because the hood fails to light up, make
sure the lamps are well mounted .
Cleaning
To clean the outside of the hood use a cloth
moistened with denatured alcohol or neu-
tral liquid detergents. Never use products
containing abrasives.
11