Base Stand Assembly Instructions; Remote Control Installing Batteries - Haier L39B2180 Manuel D'usage Et Entretien

4. Base Stand Assembly Instructions

Parts
needed for base stand assembly
Rear cabinet of TV
TV stand
Screws:4 x B4 x 16 (supplied)

5. Remote Control Installing Batteries

1). Open the battery compartment cover on the back of the remote control.
2). Insert two 1.5V AAA size batteries observing the polarity markings inside the battery
compartment. Don't mix different types or used batteries with new ones.
3). Close the cover.
Batteries shall not be exposed to excessive heat such as direct sunlight or fire.
- The remote control should be operated within 23 feet (7m) and 30
IR receiver at the front of the TV.
- Used batteries should be disposed of properly
Step 1
Battery
Compartment
Cover
Note: the pictures below are only for reference
Installation
(Gently place the TV face down on a soft, flat surface, such as a blanket,
foam, or cloth.)
1. Put the stand on the TV set
2. Screw the stand in the positions with the screws supplied (4 x B4 x 16).
Step 2
2 x AAA Battery
Introduction
Screws: 4xB4x16
0
to the left and right of the
Step 3
9