Repair Instructions - Rosenbauer HEROS-xtreme Mode D'emploi

Rosenbauer - User Guide HEROS-xtreme

8. Repair instructions

8.1 Chinstrap replacement
As described in Section 5.2, the chinstrap can be removed using an Allen key
and then reinserted using the reverse procedure. The chinstrap is then to be
properly adjusted as explained in Section
8.2 Visor replacement
Firstly, the two screws (hexagonal socket)
must be loosened.
The visor should then be removed from
its anchorage.
A new visor is then inserted onto the seating
bolts and the supports pushed into the plastic
lugs. These are then secured by the holding
screws. (WARNING: Take care that the
enclosed spring washers sit properly!)
8.3 Eye protection visor replacement
Firstly, loosen the three main screws
(hexagonal socket) on the right, left and
at the rear.
Then remove the shaft of the mechanism
from the turning knob, before taking the
entire interior harness out of the helmet.
Subsequently, loosen the two holding
screws (hexagonal socket) oftheeye
protection visor anchorage and exchange
the visor.
38 38