Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7
troubleshooting
Problems
The appliance does not
work
Temperature inside the
appliance is not low enough
or too high
The appliance works
continuously.
The appliancegenerates
unusual noises.
Certain sounds can be heard during normal use of the appliance, which do not affect its correct operation.
Sounds, which can be easily prevented:
• noise caused by the appliance which is not level - adjust the position with the adjustable turn-in front feet. Alternatively, place
pads made of soft material under the rear rollers, especially when the appliance is placed on tiles.
• touching the adjacent piece of furniture - move the refrigerator away.
• creaking of the drawers or shelves - take out and put back the drawer or shelf.
• sounds of clinking bottles - move bottles apart.
Sounds heard during normal use are mainly due to operation of the thermostat, compressor (switching on) and cooling system
(thermal expansion and contraction of the radiator caused by flow of the cooling agent).
Possible causes
The electric circuit is disrupted.
Incorrect setting of the
thermostat.
The ambient temperature is
higher or lower than the climate
range from table with technical
specification.
The appliance is located in a
sunlit place or near heat sources.
Too much warm food loaded at
a time.
The air circulation at the back of
the appliance is obstructed.
The door of the freezer is opened
too often and/or remains open
for too long.
The door does not close
completely.
The compressor is switched on
too rarely.
Door gasket inserted incorrectly.
Incorrect setting of the
thermostat.
Incorrect levelling of the
appliance.
The appliance is touching
furniture and/or other objects.
Remedies
- check whether the plug is properly inserted into the
socket
- check whether the power cable of the appliance is not
damaged
- check whether there is voltage in the socket, by plugging
another appliance, e.g. a night lamp
- check whether the appliance is switched on by setting the
thermostat to a position above 3.
- reset the thermostat to a higher position
The appliance is adapted to operation in the climate
range from the table with technical specification.
Move the appliance to another place. Observe the
guidelines contained in the manual.
Wait 72 hours until the food becomes frozen and the
required temperature is reached inside the compartment.
Move the appliance min. 10 cm away from the wall.
Reduce the frequency of opening the door and/or shorten
the time when door remains open.
Place the food and containers so that they would not
interfere with the closing of the door.
Check whether the ambient temperature is not lower than
the climate class.
Press the gasket in or have it replaced.
- reset the thermostat to a lower position
Level the appliance properly.
Place the appliance at a location that ensures proper
clearances around it.
22
English
•
Publicité
Table des Matières
