Ferm CDM1129 Traduction De La Notice Originale page 8

LED indicator (6)
Fig. C
The charger has 1 LED indicator (6) which
indicates the status of the charging process:
LED Charger status
Red Battery charging in progress
Green Battery charging finished, battery fully charged
• F ully charging the 1.3Ah battery may take up
to 60 minutes.
• A fter the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
When the machine is not being used over
a longer period of time it is best to store
the battery in charged condition.
Fitting and removing drills or screwdriver bits
Fig. D
Always remove the battery before
mounting an accessory.
The drill chuck (7) is suitable for drills and screw d river
bits with round shaft as well as hexagonal shaft.
• H old the machine firmly with one hand
• O pen the drill chuck (7) by rotating the chuck
with your other hand in clockwise direction until
it is opened far enough for the bit to slide in.
• I nsert the shaft of the drill or screwdriver bit
• T ighten the drill chuck again by firmly rotating
the chuck (7) counterclockwise.
• C heck if the bit is centered well by shortly
activating the machine´s on/off switch.
Adjusting the gears
Fig. D
Never switch gears when the motor is
running, this will damage your machine.
Never put switch in the middle between both
positions, this will damage your machine.
The machine has 2 drill speeds, which can be
adjusted by sliding the gear switch (8) forward or
backwards. The number on the gear switch (8)
shows which position is chosen.
• P osition 1: For slow drilling, large drilling
diameter or screw driving. The machine has
high power at a low speed.
• P osition 2: For fast drilling or small drilling
diameter
8
Adjusting the direction of rotation
Fig. E
• S et the direction switch (9) to position
order to drive screws or to use it for drilling.
• S et the direction switch (9) to position
order to remove screws.
Switching the machine on and off
Fig. E
The on/off switch (10) is used for activating the
machine and adjusting rotation speed.
• P ressing the on/off switch (10) will activate
the machine, the further the switch is being
pushed, the faster the drill will turn.
• R eleasing the on/off switch (10) will stop the
machine.
• M ove the direction reversing switch (9) to the
middle position to lock the movement of the
on/off switch.
Adjusting the torque
Fig. E
The machine has 17 different torque settings
and a special drill mode to set the power being
transmitted to the chuck.
By rotating the torque adjustment ring (11),
screws can be driven to a predetermined depth,
which is ideal for repetitive work. The higher the
number, the more torque will be transmitted.
• S elect a low setting for small screws or soft
work material.
• S elect a high setting for large screws, hard
work materials and when removing screws.
• Y ou should preferably choose a setting as
low as possible when driving screws. Select
a higher setting if the motor slips before the
screw is fully tightened.
• F or drilling, turn the torque adjustment ring (11)
to the setting for drilling (
counterclockwise.
Ensure that the direction switch (9) is
always set to
The machine is equipped with electronic
overload protection function. When the
machine gets overloaded it will shut
down automatically. When this happens,
please wait for a few seconds to let the
overload protection reset itself.
in
in
) by fully turning it
during drilling.