Types Of Installation; Air Pressure - Binks 2100 Manuel De Service

Air pressure for atomization is regulated at the extractor. The flow
of the fluid is adjusted by the fluid valve control knob on gun,
viscosity of paint and air pressure.
PRESSURE CUP HOOKUP
(Figure 1)
For fine finishing with limited spraying. Air pressure for
atomization is regulated at extractor; fluid pressure at cup
regulator. Pressure cup is also available less regulator.
PRESSURE TANK HOOKUP
(Figure 2)
For medium production spraying (single regulator). Air pressure
for atomization is regulated at extractor, fluid pressure at tank
regulator.
PRESSURE TANK WITH 2 REGULATORS
(Figure 3)
The pressure to the tank is regulated by the first regulator. The
pressure for atomization is regulated by the second regulator.
PRESSURE CIRCULATING HOOKUP
(Figure 4)
For heavy production spraying. Air pressure atomization regulated
at extractor. Fluid pressure regulated at fluid regulator.
SIPHON FEED HOOKUP
(Figure 5)
Air pressure for atomization is regulated at extractor. The amount
of fluid is adjusted by fluid control screw on gun, viscosity of
paint, and air pressure.

AIR PRESSURE

Atomizing pressure must be set properly to allow for the drop in air pressure
between the regulator and the spray gun.
WITH 60 PSI APPLIED AT AIR SUPPLY
5/16"
RECOMMENDED
48 PSI at gun inlet
25 feet of 5/16" I.D. hose causes
a drop of 12 PSI between the air
supply and the gun. For this
reason Binks recommends the use
of 5/16" hose.
77-3046-R2.6 (2/2016)

TYPES OF INSTALLATION

Cross section view
showing comparison of inside
hose diameters (actual size).
60 lbs. regulated pressure
NOT RECOMMENDED
Only 34 PSI at gun inlet
25 feet of 1/4" I.D. hose causes
a drop of 26 PSI between the air
supply and the gun.
Oil & Water
Extractor
FIG 1
Oil & Water
Extractor
FIG 2
Oil & Water
Extractor
FIG 3
Oil & Water
Extractor
Fluid
Regulator
FIG 4
Oil & Water
Extractor
FIG 5
An oil and water extractor
is important
Achieving a fine spray
finish without the use of
a good oil and water
extractor is virtually
impossible.
A regulator/ extractor
serves a double purpose.
It eliminates blistering and spotting by
1/4"
keeping air free of oil and water, and it
gives precise air pressure control at the
gun.
Binks recommends using Model
HFRL-508 Oil and Water Separator /
Regulator. See your local distributor for
other models.
3 / 16
Cup Regulator
Air
Fluid Pressure Cup
Air
Fluid
Inlet
Outlet
Air
Pressure
Tank
Fluid
Air Supply
Pressure
Tank
Fluid
Return
Line
Air
Fluid
Air
Siphon Cup
.