ims PRO GOLD MULTI 210-2 Notice Originale page 21

Translation of the original instructions
• Selecting the wire diameter
Selecting the metal thickness to weld
• Selecting the arc length
• Selecting the welding position
• Setting the management torch SPOT
and DELAY mode
SEMI-AUTOMATIC STEEL / STAINLESS STEEL WELDING (MAG)
The device is suitable for welding 0.6/0.8/1.0 steel wire and 0.8/1.0 stainless steel wire.
The device is delivered with contact tip, roller groove, liner and a torch set up for 0.8 steel or stainless steel wire. For welding 0.6 wire
use a torch no longer than 3m. To change the contact tip (see fig II A). The roller is reversible 0.6/0.8. The indication on the visible
side of the roller is the diameter in use. For a 0.6 wire use the 0.6 groove.
Welding Steel or Stainless Steel requires using a specific gas mix - Argon + CO2 (Ar + CO2). The proportion of CO2 will vary
depending on application. The gas flow for steel welding is between 8 and 12 L/min depending on the environment and experience
of the welder. For specific requirements seek advice from your gas distributor.
For polarity see page 4.
SEMI-AUTOMATIC ALUMINIUM WELDING (MIG)
This welding machine is suitable for welding 0.8 and 1mm aluminium wires .
To weld aluminium, neutral gas "Pure Argon" (AR) is required. For choosing gas, ask a gas distributor for advice. The gas flow for
welding aluminium is between 15 and 25 L/min depending on the environment and experience of the welder.
Machine set-up for aluminium welding:
- Use specific rollers for Aluminium
- Set the pressure on the rollers to the minimum to avoid pinching the wire.
- Remove the capillary tube before connecting the aluminium torch with a teflon liner.
- When welding aluminium use a special aluminium torch with Teflon liner to reduce friction. Do not cut the liner near the connector!
It is used to guide the wire from the rollers. (Fig II B)
- Contact Tip: Use a SPECIAL aluminium contact tip corresponding to the diameter of the wire.
For polarity see page 4.
GOLD MULTI 210-2 / 210-4 XL / 211-4
Keep the button 2 pushed and at the
same time press the lower knob to go to
the wire diameter selection menu.
Select the diameter with the upper knob.
Then release the button 2 to validate.
Turn the upper knob to select the metal
thickness to weld.
Turn the lower knob to select the arc
length.
It gets longer (0 -> +9) or shorter (0 ->
-9) enabling to more or less penetrate
the metal. If you weld for the first time
we recommend to set the arc length to 0.
Keep button 1 pushed and turn both
knobs to select the welding position.
• Press button 3 repeatedly to select
Normal mode.
• Still pressing the button 3, turn the
upper knob to get to the SPOT mode.
Adjsutable between 0.5 to 5 sec.
In the same way turn the lower knob to
configure the DELAY mode. Adjustable
between 0 to 5 sec.
+
+
+
EN
21