Piaget 504P Mode D'emploi page 8

524P 524P
Adjusting the functions Self-winding mechanical movement, date
Winding the movement
Self-winding watches are wound by the movement of the wrist when the watch is worn. If the watch
has not been worn for around 42 hours, wind it by hand with the crown in position 0, that is, turn the
crown in the forward direction (around 10 turns of the crown are sufficient to restart the mechanism).
Setting the time
FORWARD
AVANT
Pull the crown out to position 2, then turn it forward or backward to position the hands.
The mechanism is equipped with a balance-stopping device. Pulling the crown to position 2 will stop
0 - 1 - 2
the movement. Push the crown back to position 0 after the adjustment.
Setting the date
Pull the crown out to position 1, then turn it forward to select the desired date. Since the date
change occurs at midnight, make sure you distinguish midnight from noon when proceeding to the
BACKWARD
ARRIÈRE
adjustment. In order to avoid damaging the mechanism, we advise you not to adjust the date between
9 p.m. and 3 a.m. Push the crown back to position 0 after the adjustment.
Date
- 12 - - 13 -