Adjusting The Functions - Piaget 882P Mode D'emploi

882P

Adjusting the functions

Winding the movement
Self-winding watches are wound by the movement of the wrist when the watch is worn. If the watch has
not been worn for around 50 hours, wind it by hand with the crown in position 0, that is, turn the crown in
the forward direction (around 10 turns of the crown are sufficient to restart the mechanism).
Setting the time in the main time zone
The mechanism is equipped with a balance-stopping device. Pulling the crown to position 2 will stop the
movement. Pull the crown out to position 2 then turn it forward or backward to position the hands. Push
the crown back to position 0 after the adjustment.
Setting the time in the second time zone
The corrector at 10 o'clock enables you to change the time in the second time zone, which is located in
the counter at 9 o'clock. Pressing once advances the time by one hour.
Setting the date
Pull the crown out to position 1 then turn it forward or backward to select the desired date. Since the
date change occurs at midnight, make sure you distinguish midnight from noon when proceeding to the
adjustment. In order to avoid damaging the mechanism, we advise you not to adjust the date between
9 p.m and 3 a.m.
It is essential to manipulate the correctors using the appropriate tool delivered
in the case, to take your time and to ensure that they have been pushed in fully
before proceeding with any other adjustments.
12
Using the chronograph function
Successively pressing the push-button (F) located at 2 o'clock starts and stops the chronograph. Once
the chronograph has been stopped, reset to zero by pressing the push-button (G) located at 4 o'clock.
Display of the time measured
Seconds: by the chronograph seconds hand (C)
Minutes: on the counter at 3 o'clock (E), which displays the number of minutes elapsed (up to 30
minutes). The hand of this counter advances by one unit for each turn completed by the sweep-seconds
chronograph seconds hand (C).
Using the flyback function
The flyback function allows you to reset to zero and instantly begin timing again. To activate this function,
press the push-button located at 4 o'clock (G) while the chronograph is in operation. The chronograph-
seconds hand (C) and the chronograph minute counter (E) return to zero and instantly begin counting
again.
I
A
0
24
D
18 6
20 10
12
H
C
B
F
Start Stop
G
Flyback Back to 0
E
13