Bartscher 70 Série Mode D'emploi page 26

In order to replace the selector, the thermostat, the safety thermostat, the lamps, and the main
terminal board, it is necessary to unscrew the fixing screws of the control board. Then remove the
control board, disconnect the component electric cables, and replace the component. After the
replacement connect the electric cables following the instructions in the wiring diagram.
WHEN SUBSTITUTING ANY COMPONENTS, ONLY ORIGINAL SPARE PARTS
SUPPLIED BY THE MANUFACTURER HAVE TO BE USED. THE OPERATION HAS TO
BE CARRIED OUT BY AUTHORIZED PERSONNEL.
THE MANUFACTURER RESERVES THE RIGHT TO MODIFY WITHOUT NOTICE
THE FEATURES OF THE APPLIANCES DESCRIBED IN THIS MANUAL.
ELEKTRO-MULTIBRÄTER
SERIE 70
Pag. 25/39