Introduction; Specifications; Preparing The Product For Use; Unpacking - Jacto PJ-16 Manuel D'opérateur

1. Introduction

This manual contains information for the proper assembly, op-
eration and care of your sprayer. Carefully read and follow the
instructions contained in this manual before using your sprayer.
This equipment was designed for spraying plants protection
products approved by regulatory authorities to be used in knap-
sack sprayers.

2. Specifications

Model
Net weight
Gross weight
Spray lance length
Hose length
Chemical tank
Capacity
Filling opening diameter
Material
Pump
Type
Maximum working pressure
Nozzle installed
Material
SAFETY GUIDELINES – DEFINITIONS
It is important for you to read and understand this manual. The infor-
mation it contains relates to protecting YOUR SAFETY and PREVENTING
PROBLEMS. The symbols below are used to help you recognize this in-
formation.
DANGER!
Indicates an imminently hazardous situation which, if not avoid-
ed, will result in death or serious injury.
WARNING!
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION!
Indicates a potentially hazardous situation which, if not avoided,
may result in minor or moderate injury.
Notice: Used without the safety alert symbol indicates a potentially haz-
ardous situation which, if not avoided, may result in property damage.
SAVE THESE INSTRUCTIONS: This manual contains important
safety instructions for the proper use and maintenance of this
product.

3. Preparing the Product For Use

3.1. Unpacking

Take out of the sprayer carton the following parts:
4/53
PJ-16
4.9 kg
5.3 kg
600 mm
1350 mm
16 l
105 mm
Polyethylene
Piston
6.8 bar
Blue adjustable cone
Brass
Lever
Trigger Valve
Rod
Accessories plastic bag
Contents of the plastic bag
NOTE: Minimum space needed for use, maintenance and repair
is 1,5 m².
CAUTION!
Be careful when taking out the sprayer out
of the carton because the lever is loose and
can cause damage or personal injury. Note
that the agitator is loose inside the tank and
must be properly assembly.
NOTE: Carton can be discarded in recyclable waste.
• Open the tank lid and visualize the agitator;
• With one hand pull up the chamber, but without removing
it from the tank, up to the level it will be possible to fit the
agitator in its body (Image A). With the other hand, fit the ag-
itator and make sure it is firm and tight;
• Lower the chamber with the agitator assembled until it fits in
the cylinder (image B).

3.2. Installing the shaft

• Fit the shaft (1) into the free orifice on the
• sprayer base (chamber side).
• Use a plastic hammer to strike the shaft smoothly until the
hole on the shaft end matches the hole on the base reinforce-
Lance
Manual
(A) (B)
Tank